Oil spill on deck The Club recently saw an incident where a number of unfortunate events, including the fall of the vessel’s spare main engine cylinder liner, led to an oil spill. Although the oil spill was minor and contained on board, and no people were injured, the incident still resulted in a significant claim. The incident provides some valuable lessons on the potential risks, which may not always be clear, when a vessel gets caught in heavy weather. What happened? A ballasted crude oil tanker arrived at its load port early in the morning and contacted the local Vessel Traffic Services (VTS) who instructed the vessel to drift ten nautical miles off the coast to await berthing. The vessel’s main engine was kept on ten minutes notice and used to occasionally reposition the ship while drifting. The following night the wind picked up with reported gusts of up to 60 knots and the master decided to use the main engine to counter the heavy rolling. After about half an hour the main engine was stopped again. Shortly after the engine room advised that a spare main engine cylinder liner had fallen from its securing rack damaging a fuel pump and disabling the main engine. The engine room crew began to move and re-secure the fallen liner in order to restore propulsion. Meanwhile on the bridge the second officer (2/0) noticed heavy fuel oil on the main deck, which the 2/0 suspected was coming from one of the bunker tank vents. At this point the vessel was rolling about 30 degrees as well as heaving violently. The master informed the head office who advised the port authorities of the vessel’s condition and a tug was dispatched to the scene to be on standby. After about 15 hours the engine room crew succeeded in isolating the main engine fuel pump no.1 and restored propulsion. The vessel proceeded to the load port where it became evident that fuel residues had covered a large area of the vessel (over 8600 m 2 ), including the hull, main deck and accommodation block. The terminal required all oil residues to be removed before the cargo operation could commence. The ship shifted to another jetty where a 21-day clean-up operation was conducted. What caused the incident? After reviewing the incident and analysing the events, it is likely that the following factors may have contributed to the incident: Immobilising of the main engine Once the main engine was immobilised, the vessel encountered heavy rolling/pitching. The rolling resulted in a small quantity of fuel oil being spilled on to the main deck through the vent head of one of the forward bunker tanks. Here the strong wind caused the fuel oil to spread to large areas of the vessel. Securing of the cylinder liner The liner had been placed and secured during dry dock just a few months before the incident. The arrangement for securing the cylinder liner consisted of two c-clamps: one placed at roughly mid-point and the other almost at floor level. The c-clamps were secured to the steel frame of the cylinder liner rack by a bolt and plain washer through an elliptical hole on each side of the steel frame. From the size of the elliptical hole, it appeared that no washer had been mounted between the nut and the steel frame. Vibrations had then caused one of the nuts securing the top cclamp to enlarge the elliptical hole until the nut was able to slip through. Heavy weather precautions According to the chief engineer, the crew members had inspected and secured all loose items in the engine room as par